[slinkelist] Launching CDJ Via Batch File

[Tang, George]

That would be a problem, because for that to happen, you'll need some other
software to be listening from the cm11a computer module for your x-10
command in order to launch CDJ.  Then you'll need to disable that software
before CDJ runs in order for it to see the cm11a since only 1 software can
have access to the cm11a serial port at a time.  Unless you don't want CDJ
to have control of x-10, then that's not a problem.  But either way, you'll
need to write a custom software to be the initial x-10 listener.

-G

-----Original Message-----
From: slinkelist-admin@nirvis.com [mailto:slinkelist-admin@nirvis.com]On
Behalf Of Marc Parker
Sent: Friday, July 07, 2000 10:37 PM
To: slinkelist@nirvis.com
Subject: [slinkelist] Launching CDJ Via Batch File


I am interested in launching CDJ via an ascii out from a home automation
controller (Stargate). I understand this can be done using a batch file, but
am not proficient in their use.

I ultimately want to be able to start up CDJ from an X-10 command.

Can anyone help out on this....

Thanks
Parker



_______________________________________________
slinkelist maillist  -  slinkelist@nirvis.com
http://www.nirvis.com/mailman/listinfo/slinkelist