[slinkelist] Slink-e problems with external receiver modules

[Ian Cole]

Have you enabled that IR port in slinkeserv? Go to View | Settings - I
suggest reading the documentation if you haven't used the IR matrix before.

Have you added a IR device file that uses that IR port (or all ports?)
Memory tells me even when it is enabled, you must have a device (or
lowlevel) enabled using that port before you will see any traffic in CDJ
(I'm assuming that's where you are looking for signs of life.)


Ian
----- Original Message -----
From: Max Spring <mspring@employees.org>
To: <help@nirvis.com>; <slinkelist@nirvis.com>
Sent: Tuesday, June 27, 2000 12:34 AM
Subject: [slinkelist] Slink-e problems with external receiver modules


> I have problems in getting an external receiver module to work with the
> Slink-e:
>
> Most of my telephone cables don't work at all.  I guess either because
they
> don't have 4 conductors, or they have it in the wrong order.
>
> By using one particular cable (presumably the one I got with the Slink-e
months
> ago) shows some sign of life: Whenever I plugin or unplug a receiver
module,
> the control LED flashes.  Also when I send IR signals to that module, the
> control LED flashes, too.
>
> However, the Slink-e doesn't seem to notice anything of it.  Whereas,
using the
> build-in IR receiver works great.
>
> I'm confused.  I'd appreciate if someone could help me further.
>
> Regards,
> -Max
>
>
>
> _______________________________________________
> slinkelist maillist  -  slinkelist@nirvis.com
> http://www.nirvis.com/mailman/listinfo/slinkelist
>